For the tower, I had a sphere and basically cut it in half. Then, I added a cylinder below it
for the mid-part of the tower.  Some small cylinders for antenna were added on the top.  Some 
larger cylinders were used for the legs.  The 8 legs around the outside are apart by 45 degrees. 
There is a larger leg down the center.  Near the end, a texture was added.
	The building started with a 1x1x1 cube.  It was rotated on the y-axis until it looked "right."
Then it was stretched and moved into its location.
	The road was built similar to the building, except the dimensions were different.
It tooks some time to get the location correct and the z length.    Some values
for crand and diffuse for the finish were tested until one was chosen.  The curbs are very
similar to the road, except with slighty different dimensions and locations.  The meridian
was built by putting two cylinders at the end of a rectanglar prism.  They it was rotated and
moved onto the road.
	The sign started with a 1x1x1 cube.  Again, it was rotated on the y-axis until
I was happy with the result.  Some narrow rectangles were added to the sign for sign legs.
Getting the correct y position and y length took some trial and error.  Then, the whole
sign was move to its position.
	The sky and ground is just taken from some existing code.  Some of the ground
attributes were modified, like colour.